Need to use some USB-to-UART serial devices from within Windows 10 and Windows 8.1 VMs. VMware Workstation Pro 15 on a Windows 10 host. The solution I found is to change the USB compatibility setting of the VM from USB 3.0 to USB 2.0. Unable to open serial port" would appear, even though Windows Device Manager indicated ports were working correctly. PuTTY) tried to open COM ports in Windows VM for CP210x-based USB-to-UART devices.Įrror messages such as "Unable to open connection to COM4. hackrf - All you need is the host tools, specifically, hackrf_spiflash.I was having errors when certain applications (e.g.dfu-util 0.8 is recommended, as it is the most extensively tested with the HackRF hardware and build software. dfu-util 0.8 or newer - Used to load and run the stock HackRF firmware from RAM.Wait until the file transfer is complete.įor Linux and Mac OS X users, you will need a few tools installed on your computer before you begin: A virtual disk with NRF52BOOT (or TECHOBOOT) label should appear in your "File manager" afterwards.ĭrag the downloaded firmware file by your pointing device (mouse, trackball.), then drop it into NRF52BOOT (or TECHOBOOT) disk. In order to simplify the firmware transfer, the bootloader emulates a "USB Mass Storage" interface.ĭownload appropriate version of the SoftRF firmware from this location Ĭonnect the SoftRF Badge Edition device to your PC by means of a USB cable (Type-A Type-C) ĭouble click (within 0.5 seconds) onto the SoftRF device RESET button. The Bootloader is capable to self-program an application firmware into the device. The board typically comes with factory pre-installed Adafruit_nRF52_Bootloader. Use Windows command line tool to execute firmware flashing procedure as follows:.Download appropriate version of the SoftRF firmware from this location and unzip the archive.You might also need to install a driver for the CP210X USB to UART bridge from Silicon Labs prior to first use of the CubeCellflash tool Take CubeCellflash for Windows (Linux and MacOS variants are also available there) download tool from this location:."Stock" modules may also require to apply full flash memory erase (use ERASE UI "button") prior to first flashing with SoftRF's firmware. Press START button and wait for completion.įor some boards you may need to push BOOT button in order to activate flash download mode.Select COM port, enter partition files and addresses, select options a driver for the CP210X USB to UART bridge from Silicon Labs orĭownload appropriate version of the SoftRF firmware from this location and unzip the archive.Take ESP32 flash download tool from this location:.First-time firmware installation procedure
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |